1 files changed, 50 insertions, 0 deletions
diff --git a/dviware/dvidvi/a5bookle.com b/dviware/dvidvi/a5bookle.com
new file mode 100644
index 0000000000..9e6d536fd2
--- /dev/null
+++ b/dviware/dvidvi/a5bookle.com
@@ -0,0 +1,50 @@
+$! Given a DVI file, this command file carries out some of the steps
+$! needed to produce an A5 booklet suitable for folding and stapling.
+$! It is assumed the user has set up a page format suitable for A5 paper.
+$! The fancy pagination is done by Tom Rokicki's DVIDVI program.
+$! Note that 148mm = A5 width = half A4 height.
+$!
+$! We assume that the following symbols have been defined:
+$! a5booklet :== @disk$utils:[utilities.tex.dvidvi]a5booklet
+$! dvidvi    :== $disk$utils:[utilities.tex.dvidvi]dvidvi
+$!
+$ if (p1 .nes. "") then goto file_given
+$ type sys$input
+
+Usage:  a5booklet file[.dvi]
+
+$ exit
+$
+$ file_given:
+$ on warning then exit
+$ dvidvi -m 4:-1,2(148mm,0mm) 'p1' part1               ! create part1.dvi
+$ dvidvi -m 4:-3,0(148mm,0mm) 'p1' part2               ! create part2.dvi
+$!
+$! Now explain how to preview or PSPRINT the new DVI files.
+$!
+$ type sys$input
+
+PART1.DVI and PART2.DVI have been created; each part contains the pages that
+must be printed on the same side of the paper.  In both parts, each A4 page
+contains two side-by-side A5 pages from your original document.
+
+To preview these DVI files you need to tell DVItoVDU to display each page
+in a landscaped orientation; for example:
+
+      $ dvitovdu /xsize=11.7in /ysize=8.3in part1
+
+To create an A5 booklet suitable for folding and stapling, carry out the
+following steps (assuming you are using a LaserWriter):
+
+   1. $ psprint /land /nobanner /notify part1
+
+   2. When this job has finished, take the output and put it back into
+      the input cassette without changing the orientation in any way.
+
+   3. $ psprint /land part2
+
+   4. Depending on the number of pages, the final output may not be collated.
+      You may need to change the placement of the bottom sheet(s).
+
+$ exit
+