% original config.xdvi -- Configuration file for Type 1 rendering in xdvi. % (If you change or delete `original' in the first line of this file, % new xdvik installations won't overwrite the file.) % % This file is part of xdvik (notwithstanding its location). % % Lines starting with `%' are comments. % % This file indicates which map files are to be used when running xdvi. % (It is not used by dvips, unless you type "dvips -Pxdvi ...", which is not % likely. Doing so, however, would allow you to use the same map files % in dvips as are used in xdvi.) % % The format is the same as for dvips configuration files, except that only % the `p' and `p+' directives are used. A line % % p file.map % % clears the existing list of map files and sets the list to the given file. % A line % % p+ file2.map % % adds the given map file to the end of the list. If you use "p file.map" % anywhere other than as the first (non-comment, non-blank) line of the file, % then you are probably making a mistake. % % If a font entry is found in several files, the earlier entry will be used % (as is done in dvips). Therefore, to override font entries in the standard % file psfonts.map, you should use entries such as: % % p myfile.map % p+ anotherfile.map % p+ psfonts.map % % However, normally it isn't necessary to add any other map file here % because psfonts.map is (normally) a generated file (by the updmap % script). Instead, map files should be added to the updmap.cfg file. % % p psfonts.map