This is the beginnings of a port to VMS. The documentation is not yet complete, but the program works. To compile, set the following in MAKE.COM: Set TFMPATH to where the TFM files are located. Default is TEX$FONTS: ($ TFMPATH = "TEX$FONTS:") Set PKPATH to where the PK fonts are located. Default is TEX_PK: ($ PKPATH = "TEX_PK:") Set VFPATH to where the VF fonts are located. Default is TEX_VF: ($ VFPATH = "TEX_VF:") Set FIGPATH to where the epsf and psfiles are located. Default is TEX_INPUTS: ($ FIGPATH = "TEX_INPUTS:") Set HEADERPATH to where the header files are located. Default is TEX$POSTSCRIPT:,SYS$LOGIN:," ($ HEADERPATH = "TEX$POSTSCRIPT:,SYS$LOGIN:,") Set CONFIGPATH to where the config files are located. Default is TEX$POSTSCRIPT: ($ CONFIGPATH = "TEX$POSTSCRIPT:") Set TPIC to ",TPIC" if you want TPIC support enabled. Default is enabled. ($ TPIC = ",TPIC") Set DEBUG to ",DEBUG" if you want DEBUG support enabled. Default is enabled. ($ DEBUG = ",DEBUG") Expect 1 warning in dospecial.c To install: dvips := $DIRECTORY:dvips maketexpk := @DIRECTORY:maketexpk Make sure that all the logicals defined above (eg, tex_pk, tex_vf) are actually defined. Again, this is a first cut, with improvements to come later. It has not been thoroughly tested. More documentation will be coming later, and possibly a VMS command line interface. If you have any problems or improvements, please let me know. Xev Gittler GTE Laboratories, Inc. xev@bunny.gte.com